1. The signal of “Robot arms move up” appears abnormally
Tips and solutions: Check if the wires are loose,check if sensory switch is working normally
2. Proximity switch is too far away from sensory metal
Tips and solutions: Adjust the distance between the proximity swith and sensory metal
3. Injection molding machine Robot arm don't move up enough
Tips and solutions: move the robot arms up to theirs up limit by hand
4. Alarm"AC servo motor abnormal"
Tips and solutions: Check the error number, repair according to error numbers
5. Injection molding machine robot hit something while moving.
Tips and solutions: Check if the sensor lights are on,adjust the sensory distance. Check if there are abnormal things on X axes which scrached the robot arm.Turn off the robot,manually move the robot to the middle of X-axes, then turn on the robot.
6. injection machine don't thimble out occasionly while using injection molding machine robot automatically
Tips and solutions: wire connection not good, Check Aviation connector if plugged tighten, check if wires loosen
7. Circuit board has a problem or wire connection wrong
Tips and solutions: same solution as number 6.